AVOIDING ERRORS WHEN APPLYING RUST-ANODE® and RUST-ANODE PRIMER®
The SUSPENSION FLUID softening solvent in RUST-ANODE® and the RUSTASOLV PRIM softening solvent in RUST-ANODE PRIMER®, for application with guns, rollers and brushes, ARE NOT INTERCHANGEABLE.
Those softening solvents must NEVER be used as degreasers and/or metal cleaners.
RUST-ANODE® and RUST-ANODE PRIMER® must NEVER be agitated with a paint shaker but must be mixed only with a MIX PADDLE in the container for at least 5 minutes at medium speed.
During application, products must be mixed to keep zinc suspended.
Application on steel must be done at 5° Celsius minimum (and at least 3 degrees Celsius above the dew point).
ALL application and/or mixing equipment MUST be decontaminated of all traces of paints and/or other contaminants.
Application equipment should be cleaned immediately after use.
To keep the original properties of the product RUST-ANODE PRIMER® between uses: if the container has too much AIR SPACE once it is closed, the product must be transferred into a smaller container with minimal free air and RUSTASOLV PRIM added to the surface before sealing tightly.
RUST-ANODE®: transfer is not required. If necessary, the product can be re-balanced by adding a small amount of RUST-ANODE® Suspension Fluid.
Gloves must be worn because zinc removes natural skin oil and so can cause irritation.
Avoid any contact with and/or proximity to any form of silicone.
The SUSPENSION FLUID softening solvent in RUST-ANODE® and the RUSTASOLV PRIM softening solvent in RUST-ANODE PRIMER®, for application with guns, rollers and brushes, ARE NOT INTERCHANGEABLE.
Those softening solvents must NEVER be used as degreasers and/or metal cleaners.
RUST-ANODE® and RUST-ANODE PRIMER® must NEVER be agitated with a paint shaker but must be mixed only with a MIX PADDLE in the container for at least 5 minutes at medium speed.
During application, products must be mixed to keep zinc suspended.
Application on steel must be done at 5° Celsius minimum (and at least 3 degrees Celsius above the dew point).
ALL application and/or mixing equipment MUST be decontaminated of all traces of paints and/or other contaminants.
Application equipment should be cleaned immediately after use.
To keep the original properties of the product RUST-ANODE PRIMER® between uses: if the container has too much AIR SPACE once it is closed, the product must be transferred into a smaller container with minimal free air and RUSTASOLV PRIM added to the surface before sealing tightly.
RUST-ANODE®: transfer is not required. If necessary, the product can be re-balanced by adding a small amount of RUST-ANODE® Suspension Fluid.
Gloves must be worn because zinc removes natural skin oil and so can cause irritation.
Avoid any contact with and/or proximity to any form of silicone.
COLD GALVANIZING
